5500 immo solutions in one place - get access now!

Stephan
Posts: 13
Joined: 14 May 2012, 22:32

Postby Stephan »

Hello!
I would like to buy Immo emulator for Daewoo Tacuma 2002.

ECU:

KEMSO
S010016030
DAEWOO
1AEK
96378049

You device is suppurt this type of ECU?

Best Regards, Stephan
Attachments
2.JPG
1.JPG
3.JPG

carlabimmo

Postby carlabimmo »

Hi,
To this type ECU must use emulator immo Matiz, Tacuma, Lanos
Emulator must connect how on the picture in manual http://carlabimmo.com/presta-pl/attachm ... chment=980
before connecting ECU to the car must cut off Immo line it is 56pin or disconnect immo box

Stephan
Posts: 13
Joined: 14 May 2012, 22:32

Postby Stephan »

so it is transparent with the instructions, thanks!!

germanml
Posts: 258
Joined: 25 Jun 2012, 20:10

Postby germanml »

Hi Michal. have a costumer with a Tacuma 2003 1.6 petrol immo problem, do you know if julie 8 jumpers can work???

regards

carlabimmo

Postby carlabimmo »

Hello,
Yes, without problem can use this type emultor for this job my Friend,

germanml
Posts: 258
Joined: 25 Jun 2012, 20:10

Postby germanml »

thanks a lot Michal

germanml
Posts: 258
Joined: 25 Jun 2012, 20:10

Postby germanml »

Hi Michal, I used the Julie as you told me , but the car didn't start,,, I cut off pin 56, the blue light flash each 2 seconds, but the car didn't start , any Idea???

regards

carlabimmo

Postby carlabimmo »

Hi Friend,
please check on the emulator PCB resistor from CODE line, what walue have in Ohm.
It's first resistor how start from end of cable and go on the PCB of emulator.
He must have 10 Ohm
Thanks,

germanml
Posts: 258
Joined: 25 Jun 2012, 20:10

Postby germanml »

hi, did you mean this resistor in picture??
Attachments
IMG_0013[1].jpg
reistor from julie

germanml
Posts: 258
Joined: 25 Jun 2012, 20:10

Postby germanml »

I don't understand connections on tacuma because pin 60 is inyector please look at the picture

regards